A Few Observations Of The Ameco OCM CPO
I finally got rid of the old battery holder in the CPO with it's old GE Nicads. The replacement AA holder I had on hand just barely fit.
The CPO was first mentioned here:
https://wb9kzy.blogspot.com/2026/08/the-ameco-cpo.html
I saw this nice example of an Ameco OCM CPO on Ebay:
source: https://www.ebay.com/itm/206063029184
One thing I realized was that whoever built the CPO that I have chose to put the terminal strip inside rather than outside. I was wondering why the three screw terminals were so close to the aluminum plate, now I know. I'll have to unsolder two wires and put the terminal strip on the outside, but I may just leave it as is:
I wasn't able to find the doc for the kit version but I did find this snippet from a Trigger ad from January 1969 QST page 129:
Inflating the kit and wired prices:
.
That Ebay seller above appears to be a user of the inflation calculator !
A few other observations:
1) it uses about 90 mA key down. No wonder the previous owner had Nicads installed.
2) the key up voltage is about -2.6 volts - the key and ground terminals have to be swapped to key the CPO electronically. Also with wimpy transistors like a 2n7000 MOSFET it may not work too well.
3) the waveform and keying:
.
No shaping and more of a rounded squarewave than a sinusoid. It's not horrible but overall you can see why people migrated to the 555 based CPOs, much simpler and cheaper.
Best Regards,
Chuck, WB9KZY
http://wb9kzy.com/ham.htm
The CPO was first mentioned here:
https://wb9kzy.blogspot.com/2026/08/the-ameco-cpo.html
I saw this nice example of an Ameco OCM CPO on Ebay:
![]() |
| At $134.99 it should be in good shape ! |
source: https://www.ebay.com/itm/206063029184
One thing I realized was that whoever built the CPO that I have chose to put the terminal strip inside rather than outside. I was wondering why the three screw terminals were so close to the aluminum plate, now I know. I'll have to unsolder two wires and put the terminal strip on the outside, but I may just leave it as is:
| see the three overlapping holes at the bottom, a tight fit |
I wasn't able to find the doc for the kit version but I did find this snippet from a Trigger ad from January 1969 QST page 129:
Inflating the kit and wired prices:
.
That Ebay seller above appears to be a user of the inflation calculator !
A few other observations:
1) it uses about 90 mA key down. No wonder the previous owner had Nicads installed.
2) the key up voltage is about -2.6 volts - the key and ground terminals have to be swapped to key the CPO electronically. Also with wimpy transistors like a 2n7000 MOSFET it may not work too well.
3) the waveform and keying:
.
![]() |
| no shaping |
No shaping and more of a rounded squarewave than a sinusoid. It's not horrible but overall you can see why people migrated to the 555 based CPOs, much simpler and cheaper.
Best Regards,
Chuck, WB9KZY
http://wb9kzy.com/ham.htm






Comments